After 13 years development GN has been the leader of solids control equipment. We had built three plant with more than 800000 square meters to manufacture different solids control and waste treatment equipment .Most GN equipment is used for drilling mud treatment to remove its solids and clarify the mud again for reuse . Actually GN equipment not only an be used for the oil gas industry ,but also good performance at some environment projects. Such as the waste water treatment. Last week we delivered vertical cutting dryer and screw conveyor to our customer .

The vertical cutting dryer is not used to treat the drilling cutting , which is used to dryer the solids phase that separated from shale shaker in the waste water treatment project. As usual , the solids discharged from shale shaker is very wet, it is inconvenient to transport, so we need to dryer it .GN vertical cutting dryer is big capacity machine with 50 tons /hour. And it is continuous work .After treatment the liquid content is only 8%-20% according to the different situation .It is a stable equipment ,the inside screen is processed with the special technology and anti -wear material. That can ensure the long lifetime . from the picture you can see that it install in a container ,that is because this project is a very cold area and it is also convenient for transport.

Except the cutting dryer , we also equipped the screw conveyor to feed material to cutting dryer ,solids will directly convey from shale shaker. This will help to improve the efficiency and reduce the cost of labor . The screw conveyor can increase the length according to the actual requirement , you just need to add the module section ,each section is 12 feet. Big capacity and stable.

GN has full experience in the solids-liquid separation ,not only in the oil gas industry ,but also environment project , if your project have demanded in these equipment , please contact us.