This question was broght by the customer, when the client get this, do not know how to do with it, how to control the vacuum pressure of the vacuum degasser vessel? and so on.

Open the bale valve beside the pressure gauge, and check make sure the pressure is between 0.25~0.4Mpa.

The sensor is for emergency, if something goes wrong, the fluid level goes up, the sensor will stop the vaccum degasser.

Here is some simple guide of the sensor:

Do not use and transportation process in the strong shaking or impact device. Instrument in the transport and storage period, the environment temperature does not allow lower than -40 ℃ and above +80 ℃, relative humidity is not more than 85%, and the surrounding does not contain any corrosive gas, no strong electromagnetic field; useing the original distribution box during transportation,.To avoid wet-stained and a variety of chemical substances pollution the greasy stain and damage the surface of the probe surface.

The instrument contains a number of patents from research, with a new signal processing technology, it has advantages of safe, clean, high precision, long life, reliable, easy installation and maintenance, simple reading etc; Widely used in petroleum, chemical, water treatment, steel, coal, electricity and food processing industries, suitable for acid, alkali, salt, anti-corrosive, high temperature, explosion-proof and other areas. The instrument can be connected to a variety of DCS system through 4~20mA or RS485 (modbus/protocol), provide real time level data for industrial automation operation.

Contact GN Solids Control Sales team to get more information or instruction.