The Final Stop / Destination of drill cuttings waste
We all knew that people are more strict on environment protection, for drilling waste, we know we need make it environment friendly, then dump. The final step of drilling waste cuttings waste is solidification, thermal desortion, injection back, or eat by germs. Solidification of wastes involves the production of a solid mass having sufficiently high structural integrity to allow transport and /or disposal of the solid without requiring secondary containment. This technology converts hydrologic sensitive liquid and semi-liquids waste in a physical form that can be stored safely.
Then it is part of the real nature, from the end to the beginning.

Drill Cuttings Waste Solidification Unit Introduction
It is not born for the oil drilling waste market, as we did not even keep in mind we need to do this before.
Mainly it consist of collection box for drill cuttings waste, cement, absorber, other chemicals. Screw conveyors to collect them all to the mixer, a big one collect waste, two small one collect from small box, but to the same end; another screw, a screw mixer.
The high-shear mixer mixes all the material, and push to the front at the same time. When the solids go to the discharge port, it is already mixed sufficiently, then discharge.

What do you want?
1) A final stop for OBM WBM drilling waste.
The drilling cuttings stabilization /solidification unit provide an effective method for processing oil- base waste and water based waste; In a result, it produces an environmentally safe, dry material that is acceptable for onsite, or land farming disposal at an approved waste facility.

2) An ONE STOP SOLUTION
Here we are!
After GN produced the solidification /stablization unit, now GN can do all this closed-loop drilling mud recycling process.
From Solids Control, to the cuttings dryer, centrifuge, then stablization unit.