shaker screen GN Shaker Screen

Shaker Screens

  Improve your solids control efficiency

Live consultation

GN Solids Control Feeding Pump

GN Solids Control has provided thousands of feeding pumps includes centrifugal pumps, screw pumps, submersible pump etc. GN Solids Control feeding pumps are widely used in 70 plus countries and regions.
One of GN customers in USA purchased 1 set GN mud cleaner years ago, they are planning to purchase GN centrifugal pumps to feed those 2 sets cyclones. centrifugal pump
QUESTION: When plumbing the overflow from the de-sanding cones directly to the inlet to the
desliming (mud) cones is the pressure loss minimal such that the 4" cones will still operate efficiently?
If the slurry flow pressure entering the inlet to the 10" hydro cyclones is at least 60 psi or more would the pressure of the overflow/outflow from the 10" cones going directly to the 4" cone bank be sufficiently high enough for the 4" cones to operate properly?
I called yesterday but could not reach you. My question is critical to our decision on a pump (s) for the unit in question. Our slurry is 16 mesh minus with most of it around 60 mesh and the slurry (pulp) density is about 1.28. Is it just as efficient to pump directly to the 4" cones and bypass the 10" cones?
Will the 10" cones operate at 70 psi or is that too high?......assuming we have to go through the 10" cones first. I was told that the cones will not operate at 80 psi which was our thoughts thus the question for 70 psi. I know they spec out at 35 to 58 psi. One pump can be used to feed the 10inch and 4inch cyclones at the same time, but it cannot be used to pump into 10inch cyclones first and connect the overflow pipe with 4inch feeding inlet. GN Mud Cleaner
70psi can be used in your situation. Yes, it's better not to overpass 80psi as some turbulent flow will occur when the pressure is too large.

Solids Control Equipment

Also need shale shaker, mud cleaner, decanter centrifuge, and drilling waste management system.

shaker supplier

Contact Us

 
Phone: +1-713-878-0880
     +1-713-320-3868
E-mail: usaThis email address is being protected from spambots. You need JavaScript enabled to view it.

This email address is being protected from spambots. You need JavaScript enabled to view it.  

America Market Manager

You are here: Home Blogs GN Solids Control Feeding Pump

Replacement Screen for Elgin Shaker

Replacement Screen for FSI Shaker

Replacement Screen for Vortex Shaker

Wordwide perspectives

Contact Us:

Phone:
+1-713-878-0880
+1-713-320-3868

E-mail:
usaThis email address is being protected from spambots. You need JavaScript enabled to view it.